How often can he recharge in one cleaning cycle ?
发表在 晒机&评测 2017-08-10 14:57:59 来自PC 复制链接 手机看帖扫一扫！手机看帖更爽 4 2955
Dear rockrobo engineers,
Excuse me, it was a little bit wrong before this post, now it should be okay :
First a customer say, in a cleaning cycle of an scheduled day, the robot will recharge 2 times, but it's always a rest of square meters not cleaned. He says it was not so before some time ago.
Now i have also answers from the user, of some needed questions, i think :
"I am only getting about 80 square meters on one charge. Maybe it's because I run the vacuum at maximum suction? I need the vacuum to clean approximately 200 square meters but lately it won't go over 170 square meters.
This is always during schedule cleanups. The robot goes out fully charged cleans about 80 square meters and then comes back charges up again to 80% goes out for a second cycle, comes back and stays docked until it charges up to 100%.
I need the robot to go back out to cover another 40 square meters of area that is shown on the map but uncleaned. I am talking about rooms that are seen but not entered or half of a room that is not returned to.
This was not a problem before when it went through three cleaning Cycles until the entire floor was covered."
It looks like as if comes with an update of the timer / scheduling, because he runs in the past 3 times and now only 2 times, recharged.
It would be very friendly of them, if they still have some time to look at the problem from another user, thanks a lot.
He have a room is with round about 150 square meters, and the robot often not finished the room and and then mostly also not find the dock.
Gives it a border for that, or is anything wrong ? (I have read from you in this forum, that one room should be smaller as 150 square meters, but i think that isn't the actual problem ?!)
Many thanks in advance, because they always help friendly and in "normal" conditions, your robot is really great.
With the hope for their good help and best regards